Grimrock

I am trying to figure out how to make a castle outside bridge. The only pieces I am aware of in the editor for it are: "castle_bridge_outside", "castle_bridge_outside_middle_01", "castle_bridge_outside_middle_02". "castle_bridge_outside" are the ends, got that. "castle_bridge_outside_middle_01" are middle pillars with "castle_bridge_outside_middle_02" being the pillars for it below. But when you try to put these together there are big gaps. In addition the middle pieces are higher than the ends. Its like there is another model that I am not finding.

So believe it or not, I still didn't finish the main game. I do recall a non-activated castle_outside_bridge in Forgotten River. Maybe someday I will get far enough in the game to see how it looks when it is activated (if it ever is). But I'd like to use this bridge sooner in my dungeon. Any ideas on what I am missing?

AFAIK the outside castle brigdge is just present as a ruin. You will not get a complete brigde from the pieces of the original assets...

Ya like THOM said it is several broken bridge pieces, the end pieces and the broken support pillar bits. You might try messing around with the castle bridge pieces and see if you can get something looking nice, haven't experimented much myself with that. I think we will have to wait until someone makes a completed bridge model for us, until then try using magic bridges to complete them

Bummer. I was afraid of that. Alright, maybe I will experiment with alternatives... or not.

Thanks

Keep in mind that the castle bridge does not align with the floor plane so if you want to re-create it as something you can walk on, you'll want to flatten it.

I did get something done here with outside bridge. It looks ok I guess. All I did was take two castle_bridge entities, rotate them and raise them to line up with outside entities. That's about all I can do since doing modeling is outside of where I am going go with this (Blender looks like a Space shuttle dashboard to me)